29-08-2013, 10:32 PM | #1 |
Member
Hatchling
Join Date: Sep 2012
Location: Essex
Posts: 674
|
Heat/light help
I am going on holiday on Saturday morning and my two are going to stay with relatives. I have set up their holiday home as a indoor rabbit cage with a basking light which all seemed fine until I actually put it together.
It seems that the bulb is going to be really quite low down as I have attached it inside the cage to the roof. There is no way of doing it any different and now I am panicking. I testing it and measured it before but I must have got my measurements wrong. It will be about 20 cm's above the top of Sheldons shell. I am now worrying that her shell may get burnt. They will be staying in a living room which will be warm. Am I better off just keeping the thermostat low and using a low wattag bulb? It is quite a bit rabbit cage so they will have a good temp gradient. I just don't want them to get burnt.
__________________
Emily & .... |
30-08-2013, 07:14 AM | #2 |
Senior Member
Adult
Join Date: Jul 2011
Location: Wiltshire
Posts: 5,675
|
Can you not attach two bits of wood to the sides with cable ties and fix a piece across the top at the correct height as a temp measure and then hang the bulb from there
|
30-08-2013, 10:26 AM | #3 |
Member
Hatchling
Join Date: Sep 2012
Location: Essex
Posts: 674
|
Thats what I have done (well, my dad had the idea ) to make it a bit higher but I am using a Exo Terra Glow light holder so it won't go any higher up
I don't have any other light holder than that one. Is 20 cm's too close? Even if I keep the temps lower?
__________________
Emily & .... |
30-08-2013, 01:39 PM | #4 |
Member
Hatchling
Join Date: Sep 2012
Location: Essex
Posts: 674
|
Any sugestions?
__________________
Emily & .... |
30-08-2013, 02:07 PM | #5 |
Senior Member
Adult
Join Date: Jul 2011
Location: Somerset
Posts: 3,150
|
There are pics in this thread of how Jumblebee cut out a wire at the top of the cage so that the lamp holder is on the outside of the cage.
http://shelledwarriors.co.uk/forum/s...626#post617626 |
30-08-2013, 09:53 PM | #6 |
Senior Member
Adult
Join Date: Aug 2011
Location: Vale of Glamorgan, South Wales
Posts: 2,327
|
Place the lamp holder above the cage and use a higher watt bulb?
__________________
Ross |
31-08-2013, 12:11 PM | #7 |
Senior Member
Adult
Join Date: Jul 2011
Location: Wiltshire
Posts: 5,675
|
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|